MAE 171 UCSD

Aerometrics Laser Doppler Velocimetry System Operating Instructions for MAE 171A Lab The Laser Doppler system is used to make non-intrusive velocity measurements in a fluid flow. The system used for the MAE 171A laboratory experiment has two channels

Pressure Distribution System for MAE171A Water tunnel Cylinder Drag Experiment Operating Instructions The pressure distribution system consists of a 1 cylindrical test specimen that has been configured with 13 pressure ports. A pitot tube at the inle

MAE 171A Operating Procedures (Heat Exchange Experiment) Equipment Used: (i) Heated plate (flat or finned) (ii) Heat exchange duct (designed by P.A. Hilton, Ltd.) (iii) 3 K-type thermocouples (iv) 2 multimeters (280 AC Volts and 2A Ammeter) (v) Flow

MAE126A/171A Winter Quarter 2006 ENVIRONMENTAL AND MECHANICAL ENGINEERING LABORATORY Heat Transfer Week 2. DETERMINATION OF HEAT TRANSFER COEFFICIENTS General description The experiment consists of heated plate in an air ow. Heat is supplied to th

MAE126A/171A Winter Quarter 2006 ENVIRONMENTAL AND MECHANICAL ENGINEERING LABORATORY Heat Transfer Week 3. DETERMINATION OF HEAT TRANSFER COEFFICIENTS FOR FINS General description The experiment consists of heated plate in an air ow. Heat is suppl

MAE Undergraduate Laboratory Operating Procedures (Smoke Plume Experiment) Equipment Used: (i) Peristaltic pump (Watson Marlow 505U) (ii) Peristaltic pump (Gilson Miniplus 2) (iii) Conductivity probe (iv) Electrical boxes (three) (v) Stepper motors

MAE126A/171A Winter Quarter 2006 ENVIRONMENTAL AND MECHANICAL ENGINEERING LABORATORY Turbulent plume Week 1. CALIBRATION AND PLUME BUOYANCY FLUX General description The experiment consists of a plume produced by a source of salt water at the top

MAE126A/171A Winter Quarter 2006 ENVIRONMENTAL AND MECHANICAL ENGINEERING LABORATORY Turbulent plume Week 2. MEASUREMENT OF PLUME PROPERTIES General description The experiment consists of a plume produced by a source of salt water at the top of a

MAE126A/171A Winter Quarter 2006 ENVIRONMENTAL AND MECHANICAL ENGINEERING LABORATORY Turbulent plume Week 3. MEASUREMENT OF PLUME PROPERTIES AND THE FILLING BOX General description The experiment consists of a plume produced by a source of salt w