Charging System - 2AZ-FE CHARGING CHARGING SYSTEM CH1 CHARGING SYSTEM PRECAUTION 1 2 3 4 5 6 Check that the battery cables are connected to the correct

Charging System - 2AZ-FE CHARGING CHARGING SYSTEM CH1...

This preview shows page 1 - 7 out of 18 pages.

2AZ-FE CHARGINGCHARGING SYSTEMCH–1CHCHARGING SYSTEMPRECAUTION1.Check that the battery cables are connected to the correct terminals.2.Disconnect the battery cables if a quick charge is given to the battery.3.Do not perform tests with a high voltage insulation resistance tester.4.Never disconnect the battery while the engine is running.5.Check that the charging cable is tightly connected onto terminal B of the generator and the fuse box.6.Do not check whether the generator generates current or not while terminal F is connected to the other terminals.
Background image
CH–22AZ-FE CHARGINGCHARGING SYSTEMCHPARTS LOCATIONCOMBINATION METER ASSEMBLY - CHARGING WARNING LIGHTINSTRUMENT PANEL JUNCTION BLOCKENGINE ROOM RELAY BLOCK, JUNCTION BLOCK - MAIN H-FUSE - ALT H-FUSE - ALT-S FUSE - AM2 FUSE- MET IG2 FUSE - AM1 FUSE - ECU-IG FUSE- IG1 RELAYIGNITION SWITCHA114720E01
Background image
2AZ-FE CHARGINGCHARGING SYSTEMCH–3CHGENERATORA114734E01
Background image
CH–42AZ-FE CHARGINGCHARGING SYSTEMCHSYSTEM DIAGRAMFL MAINAM2ALTALT-SAM12467Ignition SwitchI52315415ECU-IGCombination MeterC6IG1G1G2G1G12114BLLSSMMFEBPIGIGVoltage RegulatorStator CoilRotor CoilChargeGeneratorMET IG2AM1AM2IG1IG2BatteryA150000E01
Background image
2AZ-FE CHARGINGCHARGING SYSTEMCH–5CHON-VEHICLE INSPECTION1.CHECK BATTERY CONDITIONNOTICE:If the battery is weak or if the engine is difficult to start, perform the following procedures.(a)Check the battery for damage and deformation. If severe damage, deformation or leakage is found, replace the battery.(b)Check the electrolyte quantity of each cell.(1)For maintenance-free batteries:If the electrolyte quantity is below the lower line, replace the battery.If the electrolyte quantity is above the lower line, check the battery voltage when cranking the engine. If the voltage is less than 9.6 V, recharge or replace the battery.HINT:Before checking the battery voltage, turn off all the electrical systems (headlights, blower motor, rear defogger, etc.).(2)For non-maintenance-free batteries:If the electrolyte quantity is below the lower line, add distilled water to each cell. Then, recharge the battery and check the electrolyte's specific gravity. Standard specific gravity:1.25 to 1.29 at 20°C (68°F)If the electrolyte quantity is above the lower line, check the battery voltage when cranking the engine. If the voltage is less than 9.6 V, recharge or replace the battery.HINT:Before checking the battery voltage, turn off all the electrical systems (headlights, blower motor, rear defogger, etc.).2.INSPECT BATTERY TERMINAL AND FUSE(a)Visually check the battery terminals.(1)Check that the battery terminals are not loose or corroded.(b)Visually check the fusible link and fuses.(1)Check that there is continuity between the fusible links, high current fuses and regular fuses.
Background image
CH–62AZ-FE CHARGINGCHARGING SYSTEMCH3.INSPECT V-RIBBED BELT(a)Visually check the belt for excessive wear, frayed cords, etc.
Background image
Image of page 7

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture