5.06 HW - Procedure 1 Go to the University of Colorado...

This preview shows page 1 - 2 out of 2 pages.

We have textbook solutions for you!
The document you are viewing contains questions related to this textbook.
Physics Laboratory Experiments
The document you are viewing contains questions related to this textbook.
Chapter 23 / Exercise 2
Physics Laboratory Experiments
Wilson
Expert Verified
Procedure:1.Go to the University of Colorado – Simulations. Click on the Battery-Resistor Circuitsimulation, then click onRun Now!2.Using the information from “Think About This”, hypothesize the relationship between voltage and current.3.Analyze a single resistor circuit.oSelect a resistance value of your choice between .1-Ohms and .4-Ohms by adjusting the slider on the right side labeled resistance.oSelect a voltage value of 0.0 by adjusting the slider on the right side labeled voltage.oRead the current (Amps) from the ammeter on the lower left connected to the pinwheel. Record the values in Table 1.oSelect a new voltage and read the current. Record these values in Table 1. Repeat for 3 more trials.oUsing Graphical Analysis, construct a graph of your data with Voltage on the y-axis and Current on the x-axis.Table 11.oVoltage calculated (Volts)Current(amps)10.00.021.25.032.49.043.614.054.819.0Resistance Value used ___0.27_________Ohms
We have textbook solutions for you!
The document you are viewing contains questions related to this textbook.
Physics Laboratory Experiments
The document you are viewing contains questions related to this textbook.
Chapter 23 / Exercise 2
Physics Laboratory Experiments
Wilson
Expert Verified
Slope Value= 0.266Analysis:Write a three part conclusion. Remember to include a discussion of your hypothesis, how your selected resistance and slope value compare, and discussion of any possible sources of error.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture