Lab - Troubleshooting NAT Configurations © 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 2of 14PC-B acts as a host computer and dynamically receives an IP address from the created pool of addresses called NAT_POOL, which uses the 188.8.131.52/29 range. Note: The routers used with CCNA hands-on labs are Cisco 1941 Integrated Services Routers (ISRs) with Cisco IOS Release 15.2(4)M3 (universalk9 image). The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.0(2) (lanbasek9 image). Other routers, switches and Cisco IOS versions can be used. Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in the labs. Refer to the Router Interface Summary Table at the end of this lab for the correct interface identifiers.Note: Make sure that the routers and switch have been erased and have no startup configurations. If you are unsure, contact your instructor. Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices. Required Resources 2 Routers (Cisco 1941 with Cisco IOS Release 15.2(4)M3 universal image or comparable) 1 Switch (Cisco 2960 with Cisco IOS Release 15.0(2) lanbasek9 image or comparable) 2 PCs (Windows 7, Vista, or XP with terminal emulation program, such as Tera Term) Console cables to configure the Cisco IOS devices via the console ports Ethernet and serial cables as shown in the topology Part 1: Build the Network and Configure Basic Device Settings In Part 1, you will set up the network topology and configure the routers with basic settings. Additional NAT-related configurations are provided. The NAT configurations for the Gateway router contains errors that you will identify and correct as you proceed through the lab.