HW8 - Problem 8-6: Face Milling for the creation of a...

Info iconThis preview shows pages 1–12. Sign up to view the full content.

View Full Document Right Arrow Icon
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 2
Problem 8-3 Maximum von Mises Stress is 6.693 MPa
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Problem 8-4 Maximum von Mises Stress is 46.95 MPa
Background image of page 4
Problem 8-5 Failure Mode 1 – More critical and more likely to fail at teeth than from torsion of shaft Maximum von Mises Stress = 1.9 MPa
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Problem 8-5 Failure Mode 2 Maximum von Mises Stress = 1.4 MPa
Background image of page 6
Background image of page 7

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 8
Background image of page 9

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 10
Background image of page 11

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 12
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Problem 8-6: Face Milling for the creation of a U-shape Problem 8-6: Profile Milling for the creation of a U-shape Beginning of G-code for Problem 8-6 Problem 8-7: Face Milling for ENME block Problem 8-7: Engraving for RNMR block Beginning of G-code for Problem 8-7...
View Full Document

This note was uploaded on 04/17/2008 for the course ENME 414 taught by Professor Zhang during the Spring '08 term at Maryland.

Page1 / 12

HW8 - Problem 8-6: Face Milling for the creation of a...

This preview shows document pages 1 - 12. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online