LAB 6 Final

LAB 6 Final - ARSC 010 October 24 2007 Mini-Lab Report for...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ARSC 010 October 24 2007 Mini-Lab Report for Lab 6 Circuits, Ohm’s Law and Capacitance 1. Series Circuits and Ohm’s Law Figure 1.1 2.) Parallel circuits [source: ARSC 010. Lab 6 Procedures. 2007] Drawing with Symbols: Figure 1.1 Legend = Resistor [ohms] 2Ω VM = Voltage [volts] = Voltmeter [measures] = Switch 2Ω Ohm’s Law Calculations for Figure 1.1 Circuit: V= 12v I= ?amps R= 2Ω + 2Ω + 2Ω = 6Ω To find the current in the circuit above: V=IR therefore: I= V/R And given the information above: I= 12v/6 Ω I= 2 amps Theoretical and Actual Measurements: In this situation, or any lab experiment, the actual measurements may be different from the theoretical ones because theoretical data does not take into account human error, faulty equipment, environmental conditions, etc. Theoretical data, unlike experimental or actual data, reflects what should result if everything occurs without any error. The actual data is what is collected during an experiment. This data reflects the experiment as a whole and the data is representative of all the variables, including the negative...
View Full Document

This note was uploaded on 04/18/2008 for the course ARSC 10 taught by Professor Buxton during the Fall '08 term at Marquette.

Page1 / 3

LAB 6 Final - ARSC 010 October 24 2007 Mini-Lab Report for...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online