15050-1Cap-X2020UniSpec IISam’s Master Specification110819SECTION 15050 - BASIC MECHANICAL MATERIALS AND METHODSPART 1 - GENERAL1.1SUMMARYA.Section Includes:1.Hangers and Supports:Pipe supports.2.Mechanical equipment labelsB.Related Section:1.Section 13900 - Fire Suppression:Fire Protection Sprinkler system piping.2.Section 15100 - Building Services Piping:Domestic water, reverse osmosis, sanitary drain and vent,interior storm water, and condensate piping.Piping Insulation.Pipe freeze protection.3.Section 15190 - Fuel Gas Piping:Natural and LP gas piping.4.]Section 15600–Refrigeration Systems.1.2REFERENCESA.The publications listed below form a part of this specification to the extent referenced. Publications are referencedwithin the text by the basic designation only.B.American Society of Mechanical Engineers (ASME):1.ASME B31.9–Building Services Piping.C.Cast Iron Soil Pipe Institute (CISPI):1.Cast Iron Soil Pipe and Fittings Handbook.D.Manufacturers Standardization Society of The Value and Fittings Industry Inc. (MSS):1.MSS SP–69–Pipe Hangers and Supports–Selection and Application.2.MSS SP–89–Pipe Hangers and Supports–Fabrication and Installation Practices.1.3QUALITY ASSURANCEA.Comply with rules and regulations of public utilities and municipal department affected by connection of services.B.Laws, codes, and ordinances shall take precedence except where work called for by Drawings and Specificationsexceeds code requirements in quality or quantity.C.Comply with guidelines set forth in the CISPI Cast Iron Soil Pipe and Fittings Handbook, Chapter IV, for installationof hub and spigot cast iron soil pipe.1.4]CONSTRUCTION DOCUMENTSA.Drawings and Specifications show pipe and duct sizes, general routing and location, and describe various systems.These documents describe equipment, including size, general location, usage, support, and auxiliary requirements.Contract Documents do not, however, detail certain job requirements.Drawings are intended to cover layout anddesign of the Work and are not to be scaled for exact measurements.Where specific detail and dimension formechanical Work are not shown on Drawings, take measurements and make layouts as required for properinstallation of mechanical Work in coordination with other Work on project.1.5DELIVERY, STORAGE AND HANDLINGA.Follow manufacturer's published directions in the delivery, storage, protection, installation, piping, and wiring, andstart-up of equipment and materials.
