515-lab7-instructions-mishra-20071

515-lab7-instructions-mishra-20071 - Rochester Institute of...

Info iconThis preview shows pages 1–5. Sign up to view the full content.

View Full Document Right Arrow Icon
Rochester Institute of Technology Department of Networking, Security, and Systems Administration 4050-515/4055-815 1 2007 4050-515/4055-815 Lab 6 – Basic VLANS Sign Offs Name ____________________ Activity 5 – Connecting VLANs 5.1 (5 pts) Routing across VLANs working. _________________________ Activity 10 – Additional Commands & Recovery 1) (3pts) Password removed from switch ____________________________ 2) (2pts) Switch is write erased ____________________________
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Rochester Institute of Technology Department of Networking, Security, and Systems Administration 4050-515/4055-815 2 2007 This Page Intentionally Left Blank
Background image of page 2
Rochester Institute of Technology Department of Networking, Security, and Systems Administration 4050-515/4055-815 3 2007 4050-515/4050-815 Lab 6 – Basic VLANS Overview A variety of VLANs will be configured to demonstrate collision and broadcast domain isolation, spanning tree protocol (STP) implementation, and the impact of broadcast storms. Activity 1 - Configuration 1) Configure the IP addresses of your three bench PCs on the same network as the switch (See step 4). Attach each one to a port on the 2950 switch on your bench. Use port 1 and 2 for PC 1 & PC3.Use port 14 for PC2. 2) Setup HyperTerminal, console into, and power up the 2950 Switch> 3) At the prompt, type “enable”. Switch> enable Switch# 4) Experiment with the show commands. Note that they are similar to those on the 2514s. Now, give the switch an IP address. Switch# configure terminal Switch(config)# interface vlan1 Switch(config-if)# ip address 10.10X.100.B4 255.255.255.0 (where X = 0 for startrek, X = 1 for Oz, and B = bench_number ) Switch(config-if)# no shutdown Switch(config-if)# exit 5) Configure the switch for telnet access as follows: Switch(config)# line vty 0 15 Switch(config-line)# password netlab Switch(config-line)# enable password benchB (where B = bench_number )
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Rochester Institute of Technology Department of Networking, Security, and
Background image of page 4
Image of page 5
This is the end of the preview. Sign up to access the rest of the document.

This lab report was uploaded on 04/21/2008 for the course VNSA 515 taught by Professor Mishra during the Spring '08 term at RIT.

Page1 / 8

515-lab7-instructions-mishra-20071 - Rochester Institute of...

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online