ASTM C143 - Slump of H yd raulic-Cement Concrete ASTM C-143...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Slump of H yd raulic-Cement Concrete ASTM C-143 Tim Boyer CM 442 P re-L ab Pu rpose The purpose of this lab is to provide a standard method of determining the slump of hydraulic-cement concrete, either in the lab or in the field Equipment Mold made of metal not readily attacked by cement paste; not thinner than 0.060in; be in the form of the lateral surface of the frustum of a cone with a base diameter of 8in and top diameter of 4in and height of 12in Tamping Rod round straight rod about 24in in length; both ends hemispherical P rocedure Dampen mold and place on f lat, moist, nonabsorbent, r igid surface Hold in place by standing on to foot pieces Fill mold in three layers, each about 1/3 of volume Rob each layer with 25 strokes with tamping rod When filling top layer, heap concrete above the mold then rod Strike off excess using rod Immediately remove mold by raising straight up Immediately measure slump as the difference between the top of the mold and the displaced center of surface Procedure should be completed within 2.5 min Post-L ab Test Conditions Test Conditions were normal for this procedure. Results Slump: 1.5 in Comments The procedure was followed as wri t ten and everything proceeded normally. ...
View Full Document

This note was uploaded on 04/29/2008 for the course CE 320 taught by Professor Mckinney during the Spring '08 term at Rose-Hulman.

Page1 / 2

ASTM C143 - Slump of H yd raulic-Cement Concrete ASTM C-143...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online