Sample_Test3

# Sample_Test3 - Name: ___________________________ Page 1 ME...

This preview shows pages 1–2. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Name: ___________________________ Page 1 ME 3720B Intro Fluid Thermo Eng – Spring 2008 SAMPLE Test #3 (50 minutes, open textbook only) You do not need to follow any specific procedure. Use a hand-held calculator. Problem 1. (60 pts) Use margins to write down your derivations clearly. Problems (i) and (iv) are based on the following description and figure. a b c Atmosphere Pressure = 1.01 bar Oil SG = 0.75 Water Unknown Fluid A C B A U-tube manometer is used to measure the density of an unknown fluid, as schematically shown in the figure on the left. Given: The atmospheric pressure is 1.01 bar. The density of the oil is 0.75 of that of water, i.e., SG = 0.75. Point A is in water; B is at the interface between water and the unknown fluid; C is at the interface between the unknown fluid and air. Given: a = 1 ft, b = 0.9 ft, and c = 1 ft. a b c Atmosphere Pressure = 1.01 bar Oil SG = 0.75 Water Unknown Fluid A C B A U-tube manometer is used to measure the density of an unknown fluid, as schematically...
View Full Document

## This note was uploaded on 04/28/2008 for the course ME 3720 taught by Professor Lee during the Spring '08 term at Georgia Institute of Technology.

### Page1 / 3

Sample_Test3 - Name: ___________________________ Page 1 ME...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online