HAASMiniMillQuickGuide - modified 3-14-07-1

HAASMiniMillQuickGuide - modified 3-14-07-1 - HAAS Milling...

Info iconThis preview shows pages 1–8. Sign up to view the full content.

View Full Document Right Arrow Icon
HAAS Milling Machine WPI Quick Guide MiniMill Draft March 14, 2007 Torbjorn Bergstrom Worcester Polytechnic Institute Mechanical Engineering Department
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Foreword This document is intended to assist AUTHORIZED WPI students In operating the HAAS CNC machine tools available in the Manufacturing Laboratories. This document does not replace supervised training. See one of the Manufacturing Laboratories Staff members for information on how to become AUTHORIZED. Many of the figures in this document are taken from the HAAS Automation VF/EC/HS Mill Series Control Panel Workbook available at: http://www.haascnc.com/custserv_training.asp
Background image of page 2
Operation Checklist Date______________ Time_______________ Estimated Completion Time_______________ Operator _______________________________ Check Operator _________________________ ± Setup Sheet Attached ± Power on ± Send to home position ± Load NC Code ± Load Tools ± Set Tool Offset(s) ± Load Workpiece ± Set Work Offset(s) ± Simulate in Graphics ± Reduce Rapid Rate ± Run First Part ± Run Additional Parts ± Remove Part(s) ± Remove Tools ± Clean Work Area Notes_____________________________________ __________________________________________ __________________________________________ __________________________________________ ± Work Complete Time ______________________
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Setup Sheet (Tools) N/A Overhang 9 N/A Material N/A Diameter N/A N/A Part Probe 10 8 7 6 5 4 3 2 1 Max Cut Depth # Flutes Type Tool # Å Return to Checklist
Background image of page 4
Setup Sheet (Part) Include an Isometric or top view of the part clearly indicating the Work Zero Location CAM Software used Post processor Selected Time and Date Posted Å Return to Checklist
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Power on 1. The green power button is located on the upper left side of the controller 2. Reset the Emergency Stop 3. Reset the Alarms If the machine fails to start it may indicate that it has been locked out, or that the room emergency stop has been activated. Seek one of the Lab Staff for assistance Twist it to the right and it will pop out (Pulling the button out will cause it to fail prematurely!) The emergency stop switch is located below the power buttons Press the RESET button to clear each alarm If the Alarms are not displayed press the ALARM MESGS button You will need to reset each alarm normally at startup there will be one or two. Å Return to Checklist
Background image of page 6
Send to home position POWER UP/RESTART 1. If all of the axis including the tool changer are clear to directly to the home position, Press the POWER UP/RESTART Button and wait for the machine to complete operation 2. If there is some obstruction (large fixturing, long tools) proceed to the ZERO SNGL AXIS method .
Background image of page 7

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 8
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 24

HAASMiniMillQuickGuide - modified 3-14-07-1 - HAAS Milling...

This preview shows document pages 1 - 8. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online