This preview shows page 1. Sign up to view the full content.
Unformatted text preview: throughout the object. Then for the blackest places on the project one can use a small piece of chip board to define the black areas. The whitest areas would not need to have any form of cover, so therefore you could just leave open areas where they are located. The hardest part of preparing this object would be the very intricate curves I talked about earlier. The best solution that I can come up with for this would be to use tracing paper to map out exactly where each value would be on the final shadow drawing. Once you have that I can just put all the pieces together and see what happens....
View Full Document
This note was uploaded on 03/18/2009 for the course DESIGN STU 492 taught by Professor Magallanes during the Spring '09 term at N.C. State.
- Spring '09