AgilentE3631A_DCSupply_Tutorial

AgilentE3631A_DCSupply_Tutorial - Agilent E3631A DC Power...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
Agilent E3631A DC Power Supply Tutorial 1 Introduction The DC power supply is simple, so this tutorial only contains a few bulleted notes and a simple example. There is an image of the front panel interface in Figure 1. 2 Interface Notes The power suppy can output independent values on the +6V and ± 25 V outputs. However, the digital display can only show one value at a time. For displaying the ± 25 V outputs, press the +25 V or - 25 V buttons, respectively. For the 6 V output, press the +6 V button. The “Track” button is used to set the - 25 V output as a proportion of the +25 V output setting. If the +25 V output is set to 9 V, then the - 25 V output will be - 9 V when the word “Track” appears on the bottom of the display. Track can be turned on by pressing and holding the “Track” button until “Track” appears on the display. This feature can be turned o± by pressing the “Track” button again. The power supply can be switched into a current-source mode. However, for these labs, you will only
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 2

AgilentE3631A_DCSupply_Tutorial - Agilent E3631A DC Power...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online