# Lab8_Report - Report 8 Multi-stage Ampliﬁers Name Lab...

This preview shows pages 1–3. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Report 8: Multi-stage Ampliﬁers Name: Lab Section: 3.1.3 Measure IBIAS and the DC output voltage, VOUT . IBIAS = vOUT = 3.1.4 Using the oscilloscope, plot both vIN and vOUT . Sketch the waveforms you observe. 3.1.5 Why is vOUT not sinusoidal? 1 2 3.1.7 Measure the peak-to-peak voltage of the output waveform (i.e. the voltage signal across RL ). What is the gain of the ampliﬁer when the resistive load is attached? vL,p−p = vL = vin 3.2.1 Can you hear anything from the speaker when it is directly connected to the function generator? Yes or No 3.2.3 Can you hear anything from the speaker when it is connected to the output of the ampliﬁer? Yes or No 3.2.4 Measure IBIAS 1 , IBIAS 2 , and the DC voltages at vOUT 1 and vOUT 2 . IBIAS 1 = IBIAS 2 = vOUT 1,DC = vOUT 2,DC = 3.2.5 Measure the VBE of Q2 . Is the DC voltage at vOUT 1 large enough to bias Q2 into forward active mode? VBE = Yes or No 3 3.2.6 Using the oscilloscope, plot both vIN and vOUT 2 . Sketch the observed waveforms. 3.2.7 Measure the gain vout2 /vin . vout2 = vin 3.2.8 Now increase the DC oﬀset of the input waveform to 620 mV. What happens to the waveform at vOUT 2 ? ...
View Full Document

{[ snackBarMessage ]}

### Page1 / 3

Lab8_Report - Report 8 Multi-stage Ampliﬁers Name Lab...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online