This preview shows pages 1–3. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: Slide radio out and disconnect harnesses from rear of unit (Figure 8). F i g u r e 5 F i g u r e 6 F i g u r e 7 F i g u r e 8 Step 7: Pop off two (2) trim plates, one (1) at each end of the row of switches using a small screwdriver (Figure 9). Remove two (2) 8mm bolts now revealed (Figure 10). F i g u r e 9 F i g u r e 1 Step 8: Loosen two (2) 8mm bolts near shift lever (Figure 11). They do not need to be removed. F i g u r e 1 1 F i g u r e 1 2 Step 9: Put shift lever into fourth gear, and make sure parking brake lever is down. Lift the rear of the console off the bolts you just loosened, and pull the console rearward once it is clear of the shift lever. You may have to run your fingers along the sides to break the seal if the console has not previously been removed (Figure 12). Congratulations, youre done (Figure 13). F i g u r e 1 3 Steve Young...
View Full Document
This note was uploaded on 04/15/2009 for the course MECH Mech 220 taught by Professor Ikovic during the Spring '09 term at NJIT.
- Spring '09