Final Project 1 - Lab 1 Topology Diagram S0\/0\/0 10.1.1.0\/30 S0\/0\/0 DCE S0\/0\/1 DCE 10.2.2.0\/30 S0\/0\/0 Addressing Table Device Interface IP Address Subnet

Final Project 1 - Lab 1 Topology Diagram S0/0/0...

  • Baker College
  • ENG 101
  • Test Prep
  • gotzoped
  • 3
  • 50% (4) 2 out of 4 people found this document helpful

This preview shows page 1 - 3 out of 3 pages.

Lab 1 Topology Diagram Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 S0/0/0 10.1.1.1 255.255.255.252 N/A R2 S0/0/0 10.1.1.2 255.255.255.252 N/A S0/0/1 10.2.2.1 255.255.255.252 N/A R3 S0/0/1 10.2.2.2 255.255.255.252 N/A PC 1 NIC 192.168.10.10 255.255.255.0 192.168.10.1 PC 3 NIC 192.168.30.10 255.255.255.0 192.168.30.1 Learning Objectives To complete this lab: Cable a network according to the topology diagram Erase the startup configuration and reload a router to the default state Perform basic configuration tasks on a router Configure and activate interfaces Configure RIP routing on all the routers Configure OSPF routing on all routers Configure EIGRP routing on all the routers Scenario S0/0/0 S0/0/0 DCE S0/0/0 S0/0/1 DCE 10.1.1.0/30 10.2.2.0/30
Image of page 1
In this lab, you will review basic routing. Refer back to previous material when you cannot proceed on your own. Note: Configuring three separate routing protocols—RIP, OSPF, and EIGRP—to route the same network is emphatically not a best practice. It should be considered a worst practice and is not something that would be done in a production network. It is done here so that you can review the major routing protocols
Image of page 2
Image of page 3

Want to read all 3 pages?

You've reached the end of your free preview.

Want to read all 3 pages?

  • Fall '10
  • Salvia
  • Gate, IP address, Subnetwork, Configure

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture