Strength_T_1_Spring_08

# Strength_T_1_Spring_08 - Name Student Section CIVE 1160...

This preview shows pages 1–2. Sign up to view the full content.

Student # ___________________ Section # ________ CIVE 1160: ENGINEERING MECHANICS: Strength of Materials University of Toledo – Department of Civil Engineering Test #1, Spring 2008 Closed book & closed notes. Cheating and/or communicating with anyone (other than instructor/TA) will result in course failure . Write on only ONE side of each sheet. For Problem #1, use the figure shown below. (worth 27 points) (1) Determine the average normal stress in rod AB. The diameter of rod AB is 0.50 in. State whether the rod AB is tension or compression. If σ y = 38 ksi , determine the Factor of Safety With respect to yielding in Normal Stress. Determine the average shear stress in the bolt at A. State whether the bolt at A in single or double shear? The diameter of the bolt at A is 0.40 in. If τ y = 25 ksi , determine the Factor of Safety With respect to yielding in Shear Stress. . w = 0.8 kip/ft.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 4

Strength_T_1_Spring_08 - Name Student Section CIVE 1160...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online