{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Strength_T_2_Spring_08

# Strength_T_2_Spring_08 - Name Student Section `CIVE 1160...

This preview shows pages 1–3. Sign up to view the full content.

Name _______________________________________ Student # ___________________ Section # ________ `CIVE 1160: ENGINEERING MECHANICS: Strength of Materials University of Toledo – Department of Civil Engineering Test #2, Spring 2008 Closed book & closed notes. Cheating and/or communicating with anyone (other than instructor/TA) will result in course failure . Write on only ONE side of each sheet. (worth ___ points) (1) For the applied loads shown on the shaft below, Determine the angle of twist of gear A relative to gear D. The smooth bearings at B and C allow free rotation. Tubes AB and CD have the following inner and outer diameters: d outer = 30 mm d inner = 20 mm Solid shaft BC has a diamater of: d = 40 mm All material is A-36 steel: G = 75 GPa .

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Name _______________________________________ Student # ___________________ Section # ________ CIVE 1160: ENGINEERING MECHANICS: Strength of Materials University of Toledo – Department of Civil Engineering Test #2, Spring 2008 Closed book & closed notes. Cheating and/or communicating with anyone (other than instructor/TA) will result in course failure . Write on only ONE side of each sheet.
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 3

Strength_T_2_Spring_08 - Name Student Section `CIVE 1160...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online