ME345_Lecture_29

# ME345_Lecture_29 - M E 345 Spring 2008 Professor John M...

This preview shows pages 1–2. Sign up to view the full content.

M E 345 Spring 2008 Professor John M. Cimbala Lecture 29 03/28/2008 Today, we will : Finish the example problem we started last time – designing a strain gage circuit for a data acquisition system (good exam review problem) Do another example problem to show how to compensate for lead wire effects Do C a n d y Q u e s t i o n s f o r C a n d y F r i d a y If time, begin to review the pdf module: Dynamic System Response Example Given : A quarter-bridge Wheatstone bridge circuit is used with a strain gage to measure strains up to ± 1000 μ strain for a beam vibrating at a maximum frequency of 50 Hz. all resistors and the strain gage itself are 120 Ω resistors the circuit is initially balanced at zero strain the strain gage factor is S = 2.04 the supply voltage to the Wheatstone bridge is V s = 5.00 V DC the output voltage V o is sent into a 12-bit A/D converter with a range of ± 5 V there is some unwanted noise in the signal, with f noise = 3600 Hz and amplitude = ± 0.50 mV To do : Design a circuit with the highest possible resolution (i.e., to utilize the full range of

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 7

ME345_Lecture_29 - M E 345 Spring 2008 Professor John M...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online