Yao et al_J Bact_v181p6865

Yao et al_J Bact_v181p6865 - J OURNAL OF BACTERIOLOGY,...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: J OURNAL OF BACTERIOLOGY, 0021-9193/99/$04.00 1 Nov. 1999, p. 68656875 Vol. 181, No. 22 Copyright 1999, American Society for Microbiology. All Rights Reserved. Thickness and Elasticity of Gram-Negative Murein Sacculi Measured by Atomic Force Microscopy X. YAO, 1 M. JERICHO, 1 D. PINK, 2 AND T. BEVERIDGE 3 * Department of Physics, Dalhousie University, Halifax, Nova Scotia, Canada B3H 4J1 1 ; Department of Physics, St. Francis Xavier University, Antigonish, Nova Scotia, Canada B2G 2W5 2 ; and Department of Microbiology, College of Biological Science, University of Guelph, Guelph, Ontario, Canada N1G 2W1 3 Received 28 June 1999/Accepted 7 September 1999 Atomic force microscopy was used to measure the thickness of air-dried, collapsed murein sacculi from Escherichia coli K-12 and Pseudomonas aeruginosa PAO1. Air-dried sacculi from E. coli had a thickness of 3.0 nm, whereas those from P. aeruginosa were 1.5 nm thick. When rehydrated, the sacculi of both bacteria swelled to double their anhydrous thickness. Computer simulation of a section of a model single-layer peptidoglycan network in an aqueous solution with a Debye shielding length of 0.3 nm gave a mass distribution full width at half height of 2.4 nm, in essential agreement with these results. When E. coli sacculi were suspended over a narrow groove that had been etched into a silicon surface and the tip of the atomic force microscope used to depress and stretch the peptidoglycan, an elastic modulus of 2.5 3 10 7 N/m 2 was determined for hydrated sacculi; they were perfectly elastic, springing back to their original position when the tip was removed. Dried sacculi were more rigid with a modulus of 3 3 10 8 to 4 3 10 8 N/m 2 and at times could be broken by the atomic force microscope tip. Sacculi aligned over the groove with their long axis at right angles to the channel axis were more deformable than those with their long axis parallel to the groove axis, as would be expected if the peptidoglycan strands in the sacculus were oriented at right angles to the long cell axis of this gram-negative rod. Polar caps were not found to be more rigid structures but collapsed to the same thickness as the cylindrical portions of the sacculi. The elasticity of intact E. coli sacculi is such that, if the peptidoglycan strands are aligned in unison, the interstrand spacing should increase by 12% with every 1 atm increase in (turgor) pressure. Assuming an unstressed hydrated interstrand spacing of 1.3 nm (R. E. Burge, A. G. Fowler, and D. A. Reaveley, J. Mol. Biol. 117:927953, 1977) and an internal turgor pressure of 3 to 5 atm (or 304 to 507 kPa) (A. L. Koch, Adv. Microbial Physiol. 24:301366, 1983), the natural interstrand spacing in cells would be 1.6 to 2.0 nm. Clearly, if large macromolecules of a diameter greater than these spacings are secreted through this layer, the local ordering of the peptidoglycan must somehow be disrupted....
View Full Document

This note was uploaded on 08/06/2008 for the course ESM 219 taught by Professor Holden during the Fall '07 term at UCSB.

Page1 / 11

Yao et al_J Bact_v181p6865 - J OURNAL OF BACTERIOLOGY,...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online