6.3.3.6 Packet Tracer - Configuring Router-on-a-Stick Inter-VLAN Routing Instructions.pdf

6.3.3.6 Packet Tracer - Configuring Router-on-a-Stick Inter-VLAN Routing Instructions.pdf

Info icon This preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 3 Packet Tracer – Configuring Router-on-a-Stick Inter-VLAN Routing Topology Addressing Table Device Interface IPv4 Address Subnet Mask Default Gateway R1 G0/0.10 172.17.10.1 255.255.255.0 N/A G0/0.30 172.17.30.1 255.255.255.0 N/A PC1 NIC 172.17.10.10 255.255.255.0 172.17.10.1 PC2 NIC 172.17.30.10 255.255.255.0 172.17.30.1 Objectives Part 1: Test Connectivity without Inter-VLAN Routing Part 2: Add VLANs to a Switch Part 3: Configure Subinterfaces Part 4: Test Connectivity with Inter-VLAN Routing Scenario In this activity, you will check for connectivity prior to implementing inter-VLAN routing. You will then configure VLANs and inter-VLAN routing. Finally, you will enable trunking and verify connectivity between VLANs. Part 1: Test Connectivity Without Inter-VLAN Routing Step 1: Ping between PC1 and PC3. Wait for switch convergence or click Fast Forward Time a few times. When the link lights are green for PC1 and PC3 , ping between PC1 and PC3 . Because the two PCs are on separate networks and R1 is not configured, the ping fails.
Image of page 1

Info icon This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document Right Arrow Icon