Rowan Introduction to Astronomy Lab 6 / Plotting the Orbit of the Moon Name:________________________________________________ Score:__________________________ Objectives After completing this lab, the student will be able to use a series of lunar photographs to make a scale drawing of the Moon’s orbit.be able to confirm the elliptical nature of the Moon’s orbit by determining the major axis, minor axis, and eccentricity of the orbit. Materials Needed pencil mm ruler compass (get cheap ones in dollar stores, Wal-Mart) calculator Procedure The Moon’s OrbitAs applied to the Moon’s orbit, Kepler’s first law would state that the Moon’s orbit is an ellipse with the Earth at one focus. If the Moon’s orbit is an ellipse, its distance fromthe Earth should change during one complete orbit. This means the Moon should appear larger at perigee(closest approach to Earth) than it does at apogee(farthest from Earth). Figure 1 shows a series of lunar photographs. These were obtained as the Moon passed several different positions in its orbit. It is possible to use these photographs to determine a few orbital properties of the Moon. Fill in Table columns in this order: 6, 7, 3, 4, 5 and before plotting your data points.1. Measure the diameter, d, of each lunar image shown in millimeters. Be careful not to simply measure the illuminated portion. Make all measurements vertically through the center of each image. Estimate each value to ½ millimeter (0.5 mm).Record your measurements in column 6 in Table 1. (Note: These values should range between 40 mm and 60 mm.) 2. From each diameter measurement, the relative distance to the Moon can be determined. This distance will be scaled down to fit on a piece of graph paper. Calculate the scale distance, D,(in mm) to the Moon using the relation D= 4000/d,where dis the diameter recorded in column 6 of Table 1, and 4000 is a scale factor. Record your values of D,to its nearest tenth of a millimeter, in the last column of Table 1 (column 7). Round to 1 decimal place.