hw5_spring_09_soln

Hw5_spring_09_soln - EML 6267 Assignment#5 Spring 2009 Please remember to put your name on your assignment Due Friday 1(20 pts Complete problem 1

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: EML 6267 Assignment #5 Spring 2009 Please remember to put your name on your assignment. Due: Friday, 3/6/09 1. (20 pts.) Complete problem 1 from chapter 4 of the text. a) Up milling, 30% radial immersion The radial depth of cut is 30% of the cutter diameter or 60% of its radius, r a 6 . = . Because it is an up milling operation, = s and the exit angle is: ( ) 4 . 66 4 . cos 4 . cos 1 1 = = = r r e deg. See Fig. s.4.1.a for the up milling exit angle geometry. b) Down milling, 40% radial immersion The radial depth of cut is 40% of the cutter diameter or 80% of its radius, r a 8 . = .The starting angle is: ( ) 5 . 101 2 . cos 180 2 . cos 180 1 1 = = = r r s deg and the exit angle is 180 = e deg. See Fig. s.4.1.b. 2. (10 pts.) Complete problem 2 from chapter 4 of the text. 500 60 3 10000 60 = = = t tooth N f H z Figure s.4.1.a: Exit angle geometry for up milling. e r r- a e a Figure s.4.1.b: Start angle geometry for down milling....
View Full Document

This note was uploaded on 04/23/2009 for the course EML 6267 taught by Professor Schmitz during the Spring '08 term at University of Florida.

Page1 / 4

Hw5_spring_09_soln - EML 6267 Assignment#5 Spring 2009 Please remember to put your name on your assignment Due Friday 1(20 pts Complete problem 1

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online