{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Lab5_datasheet

# Lab5_datasheet - H V max V rms T f Input Output SECTION V...

This preview shows pages 1–2. Sign up to view the full content.

ECEN 215 Team__________ LAB 5 DATASHEET SECTION II – EWB A. Printout of schematic with measured voltages B. Printout of schematic, input and output signals in oscilloscope (2 cycles) Measured time shift and calculated phase shift C. Measured periods and calculated frequencies (frequencies the same?) D. Printout of input and output signals using Display Graphs (2 cycles) SECTION IV A – C. NOMINAL MEASURED % ERROR POT C D. Measured V FG __________ V C __________ V R __________ E. Explain what is the effect observed when varying the potentiometer Answer: F,G. Plot of input and output signals (3 cycles) Estimated V max , period, V rms and frequency of each from measurements

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: H: V max V rms T f Input Output SECTION V Compare simulated results from Section II with Section IV measurements. Explain discrepancies if any. Answer: When viewing the dual traces (both signals on the same display), does the first maximum of the source voltage occur before or after the first maximum of the capacitor voltage? Answer: Why does it appear that KVL fails when applied to the amplitudes of the voltages measured for Figure 2? What missing information needs to be considered to show that the KVL actually holds true for the circuit of Figure 2? Answer: TA: ____________________________...
View Full Document

{[ snackBarMessage ]}

### Page1 / 2

Lab5_datasheet - H V max V rms T f Input Output SECTION V...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online