PSME RMP Review 2019 Quiz1 - Answer Key.pdf - PSME RMP SPLBE Review 2019 Name Date Organization 1 Modern or state-of-the-art plumbing installation ow

PSME RMP Review 2019 Quiz1 - Answer Key.pdf - PSME RMP...

This preview shows page 1 - 2 out of 8 pages.

PSME RMP SPLBE Review 2019 Name: ___________________________________ Organization: _____________________________ Date: ______________________________ 1.Modern or state-of-the-art plumbing installation ow require the close coordination of works among Master Plumbers, Architects and Engineers to come up with the most _______ and _______ plumbing installation. a.sufficient / approved b.efficient / economical c.minimum / maximum d.daring / exotic 2.Plumbing fixtures, devices and appurtenances shall be supplied with water in _______ volume and a pressure ______ to enable them to function satisfactorily and without undue noise under all normal conditions of use. a.exact / exact b.efficient / equipped c.sufficient / adequate d.half / full 3.Each family dwelling unit on premises abutting on a sewer or with a private sewage-disposal system shall have at least ______ and ________. Further, a lavatory and bathtub or shower shall be installed to meet the basic requirements of sanitation and personal hygiene. a.one wall hung water closet / double kitchen type sink b.one pedestal water closet / single kitchen type sink c.one hanging water closet / one kitchen type sink d.none of the above 4.Each fixture directly connected to the drainage system shall be equipped with a ______. 5.________ shall extend to the outer air and installed to preempt clogging and the return of foul air to the building. 6.Minimum vent pipe size for water closet. 7.Minimum vent pipe size for drinking fountain. a.2”b.2 ½c.1 ¼d.1 ½”8.A stack as defined in the code is, 9.Air pressure in drainage pipes greater than atmospheric pressure. 10.The minimum size of water supply pipe to a lavatory is, 11.A means of measurement for vertical waste or soilstack. It is equal to each floor level or storey in abuilding but are always at least eight feet (2.4m) internal. a.Vertical distance b.Main stack intervals c.Branch interval d.Horizontal interval12.A pipe fitting used to reduce the size of an opening which is threaded on both the inside and the outside is called.
Background image
Image of page 2

You've reached the end of your free preview.

Want to read all 8 pages?

  • Summer '13
  • Marvin Dalusong
  • Drinking water

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture