Ch 8 HW lab - VLSM 10 correction 3 .docx - Name Lab -...

Name _______________________
Lab - Designing and Implementing a Subnetted IPv4 Addressing
Scheme
Topology
Addressing Table
Device Interface IP Address Subnet Mask Default Gateway
R1 G0/0 192.168.0.1 255.255.255.224 N/A
G0/1 192.168.0.33 255.255.255.240 N/A
Lo0 192.168.0.3 255.255.255.224 N/A
Lo1 192.168.0.36 255.255.255.240 N/A
S1 VLAN 1 N/A N/A N/A
PC-A NIC 192.168.0.2 255.255.255.224 192.168.0.1
PC-B NIC 192.168.0.34 255.255.255.240 192.168.0.33
Objectives
Part 1: Design a Network Subnetting Scheme
 Create a subnetting scheme that meets the required number of subnets and host addresses.
 Complete the diagram, showing where the host IP addresses will be applied.
Part 2: Configure the Devices
 Assign an IP address, subnet mask, and default gateway to the PCs.
 Configure the router Gigabit Ethernet interfaces with an IP address and subnet mask.
 Create two loopback interfaces on the router, and configure each with an IP address and subnet mask.
Part 3: Test and Troubleshoot the Network
 Verify and troubleshoot network connectivity using ping.
Background / Scenario
In this lab, starting from a single network address and network mask, you will subnet the network into multiple
subnets. The subnet scheme should be based on the number of host computers required in each subnet, as
well as other network considerations, like future network host expansion.
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 4

Lab - Designing and Implementing a Subnetted IPv4 Addressing Scheme
After you have created a subnetting scheme and completed the network diagram by filling in the host and
interface IP addresses, you will configure the host PCs and router interfaces, including loopback interfaces.
The loopback interfaces are created to simulate additional LANs attached to router R1.
After the network devices and host PCs have been configured, you will use the ping command to test for
network connectivity.