15ME404L - MANUAL - Ex 1 to 4.pdf - LIST OF EXPERIMENTS Expt No Name of the Experiment Page No Introduction to CNC Programming List of G Codes and M

15ME404L - MANUAL - Ex 1 to 4.pdf - LIST OF EXPERIMENTS...

This preview shows page 1 - 5 out of 32 pages.

LIST OF EXPERIMENTS Expt. No. Name of the Experiment Page No. Introduction to CNC Programming List of G Codes and M Codes SEENC TURN 1 Manual Part Program for Facing, Step turning, Taper And Finish Turning using ordinary and canned cycle. 2 Manual Part Program for Radial Grooving, Axial Drilling and Threading using canned cycle. SEENC MILL 3 Manual Part Program for Surface Milling, Linear and Circular Interpolation and Mirroring operation. 4 Manual Part Program for End Milling and Drilling Operation. CAPSTURN 5 NC Code Generation for a given model using CAPSTURN CAPSMILL 6 NC Code Generation for a given model using CAPSMILL MASTERCAM 7 Model and NC Code Generation for a Simple profile Using Turning operation 8 Model and NC Code Generation for a Simple profile Using Milling operation 9 Model and NC Code Generation for a Simple profile Using Wire Cut Electrical Discharge Machining operation MACHINING EXERCISES 10 Machining Demonstration on FMS Turning and Milling Center 11 Machining Demonstration on CNC Turning and Milling Center
Image of page 1

Subscribe to view the full document.