CHAPTER16

# Dissolved in water at 290 k is 128 mpa consider water

This preview shows page 1. Sign up to view the full content.

This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: nitrogen gas in rubber at 25C is 0.00156 kmol/m3 bar. When phase equilibrium is established, the density of nitrogen in a rubber piece placed in a nitrogen gas chamber at 800 kPa is (a) 0.012 kg/m3 (d) 0.56 kg/m3 (b) 0.35 kg/m3 (c) 0.42 kg/m3 (e) 0.078 kg/m3 16103 Of the reactions given below, the reaction whose equilibrium composition at a specified temperature is not affected by pressure is (a) H 2 (b) CO (c) N2 1 2 O2 1 2 O2 S H 2O S CO2 Design and Essay Problems 16110 An article that appeared in the Reno GazetteJournal on May 18, 1992, quotes an inventor as saying that he has turned water into motor vehicle fuel in a breakthrough that would increase engine efficiency, save gasoline, and reduce smog. There is also a picture of a car that the inventor has modified to run on half water and half gasoline. The inventor claims that sparks from catalytic poles in the converted engine break down the water into oxygen and hydrogen, which is burned with the gasoline. He adds that hydrogen has a higher energy density than carbon and the high-energy density enables one to get more power. The inventor states that the fuel efficiency of his car increased from 20 mpg (miles per gallon) to more than 50 mpg of gasoline as a result of conversion and notes that the conversion has sharply reduced emissions of hydrocarbons, carbon monoxide, and other exhaust pollutants. Evaluate the claims made by the inventor, an...
View Full Document

## This note was uploaded on 06/15/2009 for the course MAE 3311 taught by Professor Hajisheik during the Summer '08 term at UT Arlington.

Ask a homework question - tutors are online