1.1.7 Lab - Basic Switch Configuration.docx (1).pdf - Lab...

This preview shows page 1 - 3 out of 12 pages.

Lab - Basic Switch Configuration Topology Addressing Table Device Interface IP Address / Prefix S1 VLAN 99 192.168.1.2 /24 S1 VLAN 99 2001:db8:acad::2 /64 S1 VLAN 99 fe80::2 PC-A NIC 192.168.1.10 /24 PC-A NIC 2001:db8:acad:3 /64 PC-A NIC fe80::3 Objectives Part 1: Cable the Network and Verify the Default Switch Configuration Part 2: Configure Basic Network Device Settings Configure basic switch settings. Configure the PC IP address. Part 3: Verify and Test Network Connectivity Display device configuration. Test end-to-end connectivity with ping. Test remote management capabilities with Telnet. Part 4: Manage the MAC Address Table Record the MAC address of the host. Determine the MAC addresses that the switch has learned. List the show mac address-table command options. Set up a static MAC address. © 2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 12
Lab - Basic Switch Configuration Background / Scenario Cisco switches can be configured with a special IP address known as the switch virtual interface (SVI). The SVI, or management address, can be used for remote access to the switch to display or configure settings. If the VLAN 1 SVI is assigned an IP address, by default all ports in VLAN 1 have access to the SVI IP address. In this lab, you will build a simple topology using Ethernet LAN cabling and access a Cisco switch using the console and remote access methods. You will examine default switch configurations before configuring basic switch settings. These basic switch settings include device name, interface description, local passwords, message of the day (MOTD) banner, IP addressing, and static MAC address. You will also demonstrate the use of a management IP address for remote switch management. The topology consists of one switch and one host using only Ethernet and console ports. Note : The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.2(2) (lanbasek9 image). Other switches and Cisco IOS versions can be used. Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in the labs. Note : Make sure that the switches have been erased and have no startup configurations. If you are unsure, contact your instructor. Refer to Appendix A for the procedures to initialize and reload a switch. The default bias template used by the Switch Database Manager (SDM) does not provide IPv6 address capabilities. Verify that SDM is using either the dual-ipv4-and-ipv6 template or the lanbase-routing template. The new template will be used after reboot even if the configuration is not saved. Open configuration window S1# show sdm prefer Use the following commands to assign the dual-ipv4-and-ipv6 template as the default SDM template. S1# configure terminal S1(config)# sdm prefer dual-ipv4-and-ipv6 default S1(config)# end S1# reload Close configuration window Required Resources 1 Switch (Cisco 2960 with Cisco IOS Release 15.2(2) lanbasek9 image or comparable) 1 PC (Windows with terminal emulation program, such as Tera Term)

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture