HW Assignment 2

HW Assignment 2 - Homework Recreate the sketch below All dimensions are in mm Place the center of the large circle at the origin in the sketch

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Homework ! Recreate the sketch below All dimensions are in mm. Place the center of the large circle at the origin in the sketch window. The sketch must be completely defined/constrained. Feel free to place your dimensions differently than shown. Note: The sides of the 12.30 mm spline are parallel to the vertical centerline. Homework ! Recreate the sketch to the right All dimensions are in inches. Since this sketch is in inches, place this one in a different part document than any metric sketches. Under Tools>Options, set the dimension style for this part file to ANSI inch Save the file to force the dimension style on the document Use mirroring for the two flanges on the right. Place the center of the large arc at the origin in the sketch window. The sketch must be completely defined/constrained. Feel free to place your dimensions differently than shown. Homework ! Recreate the sketch below All dimensions are in inches. Place this sketch in the same part document as the other inchdimensioned sketch. Place the center of the small central circle at the origin in the sketch window. The sketch must be completely defined/constrained. Feel free to place your dimensions differently than shown. Use Symmetry for the small circles to the right. ...
View Full Document

This note was uploaded on 07/20/2009 for the course AME 308 taught by Professor Shiflett during the Spring '07 term at USC.

Ask a homework question - tutors are online