LAB Manual E1.docx - Lab Manual Course Title Machine Design Cad-II Experiment 01 Title Introduction to sketching modelling options menu and basic

LAB Manual E1.docx - Lab Manual Course Title Machine Design...

This preview shows page 1 - 4 out of 9 pages.

Lab ManualCourse Title: MachineDesignCad-IIExperiment # 01Title:Introduction to sketching, modelling, options menu and basic rendering tools insideCreo 6.0. Equipment:CREO Software 6.0.Procedure:1)Start a new “part” file. Write the name of part “E1”.1Lab Title: ModellingandSimulationLab
Background image
Lab ManualCourse Title: MachineDesignCad-II2)Select the front plane and then click on sketch. Then after that select the rectangle i.e. the corner rectangle with the dimensions 3as its width and 5as its length.3)Click Ok to exit the sketch mode and then click extrude which is 0.5.2Lab Title: ModellingandSimulationLab
Background image
Lab ManualCourse Title: MachineDesignCad-II4)Then toward the left bottom corner of the cuboid (after selecting the surface for sketch) draw a rectangle corner rectangle stretching towards the right giving its height of 1.5.5)Then click Ok to exit sketch mode, and then extrude the surface outwards about 0.5.
Background image
Image of page 4

You've reached the end of your free preview.

Want to read all 9 pages?

  • Winter '19
  • Professor Robert
  • #, Left-wing politics, Political spectrum, The Corner, Simulation Lab

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture