final+version+A+solutions

final+version+A+solutions - EECS 40, Fall 2008 Prof....

Info iconThis preview shows pages 1–5. Sign up to view the full content.

View Full Document Right Arrow Icon
EECS 40, Fall 2008 Prof. Chang-Hasnain Final Exam Solutions Version A 8:00 am – 11:00 am, Saturday December 13, 2008 Total Time Allotted: 180 minutes Total Points: 300 1. This is a closed book exam. However, you are allowed to bring 4 pages (8.5” x 11”), double-sided notes. 2. No electronic devices, i.e. calculators, cell phones, computers, etc. 3. SHOW all the steps on the exam. Answers without steps will be given only a small percentage of credits. Partial credits will be given if you have proper steps but no final answers. 4. Remember to put down units. Points will be taken off for missed unit. Last (Family) Name:_____________________________________________________ First Name: ____________________________________________________________ Student ID: ___________________________ Discussion Session: ________________ Signature: _____________________________________________________________ Score: Problem 1 (116 pts) Problem 2 (36 pts) Problem 3 (58 pts) Problem 4 (90 pts) Total (300 pts)
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Page 2 of 17 Problem 1: Transistor Amplifier (116 pts) Note: The sub-parts are somewhat independent. Read through the entire problem even if you are not able to solve some parts. Good luck! In this problem you are about to analyze the amplifier circuit shown in the figure below. The threshold voltage V t0 = 1 V and the capacitor impedance at signal frequency is negligible. D D 2 kOhm 1 kOhm C C 150 Ohm v s *sin(wt) v in v out 5 V D D Figure 1: Amplifier circuit for Problem 1 The diodes D in figure 1 have the following I-V characteristic: I diode [mA] V diode [V] 0.7 1.0 1.3 1 2 Figure 2: I-V characteristics of diodes in circuit shown in figure 1.
Background image of page 2
Page 3 of 17 a) Derive an expression for V diode [V] as a function of I diode [A] for the “on-region” of the diode and give an equivalent circuit that has the same I-V characteristic in that region (10 pts) V diode = 0.7 + 300 * I diode Equivalent circuit: A 0.7 V voltage source in series with a 300 Ohm resistor b) Calculate V G , the DC voltage at the gate of the MOS transistor (15 pts). We basically have a resistive voltage divider between 5 V and 3 * 0.7 V, with resistors of 2000 Ohm and 3 x 300 Ohm V G = 2.1 + (5-2.1)*900/(2000 + 900) = 2.1 + 2.9/2900 * 900 = 3 V Alternatively once can solve the following equation for the current through the 3 diodes in series I diodes =(5 – 3 * V diode )/2000 = (5 – 3*(0.7 + 300 I diodes ))/2000 to get I diodes = 1 mA V G = 5 – 2000*0.001 = 3 V c) Express V GS , the DC voltage between the gate and the source of the transistor, as a function of I DS . (4 pts) V GS = V G – V diode = 3 – 0.7 – 300 * I DS = 2.3 – 300 * I DS
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Page 4 of 17 d) Assume that for a similar circuit you found out that V GS = 2.4 - I DS * 200. Using the I-V characteristic for the transistor in saturation (given below) and Load-Line
Background image of page 4
Image of page 5
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 17

final+version+A+solutions - EECS 40, Fall 2008 Prof....

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online