{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

hw_6.20091009.4aced6417507d3.43203247

# hw_6.20091009.4aced6417507d3.43203247 - Name HW 6 Chapter...

This preview shows pages 1–4. Sign up to view the full content.

Name: HW # 6 – Chapter 13 & DOE – due Oct 13 th – 36 pts 1. Multiple Choice 13.1: 2. Multiple Choice 13.2: 3. Multiple Choice 13.7: 4. Multiple Choice 13.10: 5. Multiple Choice 13.14: 6. Multiple Choice 13.15: 7. Problem 13.1 (cm 3 /s): 8. Problem 13.3 (rev/min): 9. Problem 13.16 (mm 5-digits):

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
10. Problem 13.12: a. Q max (in 3 /sec): p max (lb/in 2 ): b. K s (in 5 /lb · s): c. p(lb/in 2 ), Q(in 3 /s): 11. If the Polymer flow in an extruder is 100cm 3 /s producing a tube ( die opening is 20mm OD and 18 mm ID). What is the linear tube production velocity (m/min), assuming the swell ratio is 1.2? 12. Three parts are to be assembled together as shown below. What is the total length and tolerance of the final part assuming a) a loaf distribution and b) a Gaussian distribution? a. Loaf: b. Gaussian: 2 ± 0.1cm 2.5 ± 0.1cm 2 ± 0.15cm
13. Your parts supplier just informed you that the dimensional tolerance on the most critical part in your product have increased by 25%. Your boss wants an estimate on how much cost increase should be expected on returned products for warranty replacements.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 4

hw_6.20091009.4aced6417507d3.43203247 - Name HW 6 Chapter...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online