415.1 - Introduction

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
Introduction This lab required the use of both a LM741 operational amplifier and a LM358 operational  amplifier. Several measurements were taken to measure the behavior of both op amps, with  consideration of ideal op amp behavior. In addition, an inverting amplifier and voltage follower  were constructed to further determine electrical characteristics of op amps. Methods The procedure was followed except for the following changes:  3.2.2-3.2.3 –  A 3.3 M  resistor was utilized. The suggested range was between 2.2-4.7 M   Ω Ω 1.05 V were applied to resistor instead of the 1 V in the lab manual 3.3.2 -  Our 10 k  potentiometer had a max value of 9.54k Ω Ω We used a supply voltage of 2.45V. 3.4.2 -  We had to use only a DC offset of 0.5 V instead of the suggested 5 V to obtain a smooth  waveform. Results 
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 02/09/2010 for the course MSE 518248 taught by Professor Cahler during the Spring '10 term at University of Balamand.

Page1 / 5

415.1 - Introduction

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online