MAE+52+Midterm+Project

MAE+52+Midterm+Project - MAE 52 Midterm Project Spring 2007...

Info iconThis preview shows pages 1–5. Sign up to view the full content.

View Full Document Right Arrow Icon
MAE 52 Midterm Project Spring 2007 Due May 14, 2007 1) Create each of the following parts shown below. All measurements in inches. a. The Support (0.5 thick)
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
b. The Shaft (think – what is the diameter of the shaft which is not given if I give you the thread callout) c. The Flywheel
Background image of page 2
d. The Washer (0.5 thick) Construct all parts with Chromium Stainless Steel.
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This assembly is a belt transmission where power is transferred from the belt on the flywheel to the shaft. Create each part and generate the proper views for each part in a drawing. (Hint: What do I mean by proper?) Dimension the parts with the dimensioning method which does not stack (accumulate) the tolerance. Tolerance all parts with a symmetric tolerance of 0.010. The flywheel is to fit onto the shaft using an interference fit. Please use a Class FN2 fit (Appendix A-28). Tolerance the interference section of the shaft and hole appropriately to give this fit.
Background image of page 4
Image of page 5
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 5

MAE+52+Midterm+Project - MAE 52 Midterm Project Spring 2007...

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online