Equipotential

Equipotential - 1 ES4: PHY 152 Equipotential Surfaces and...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: 1 ES4: PHY 152 Equipotential Surfaces and Electric Field Lines SECTION V: Procedure V-0: You have been provided with conductive paper upon which the three types of patterns shown in Fig.0 on three separate pieces of graphite paper using conducting silver paint. V-1: Use graphite sheet No. 1 shown in fig.0 with a white sheet of paper underneath. Use the circuit shown in fig.1 to find a point at potential V = 2 Volts as follows: You scan the graphite paper with the probe tip A of voltmeter electrode (by lightly dragging it across the surface) until the voltmeter reads 2 Volts. You then insert the tip in the graphite paper so as to make a small hole. Using the same method locate 10-12 points at V = 2 Volts. Repeat the process above for V = 4, 6, and 8 Volts. This will result in a series of holes in the white paper for each voltage. Label each group of points and your electrodes with the corresponding value of V on the white paper beneath the sheet with the painted on electrodes. Be sure to poke a few holes at the edge of each electrode so that you can tell where the electrodes are on the white piece of paper....
View Full Document

This note was uploaded on 02/20/2010 for the course PHY 152 taught by Professor Brewer during the Spring '08 term at SUNY Buffalo.

Page1 / 3

Equipotential - 1 ES4: PHY 152 Equipotential Surfaces and...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online