This preview shows pages 1–3. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: 4*. Determine the allowable uniformly distributed load w for the beam shown, knowing that all = +70MPa in tension, all = -130MPa in compression. 5. 6*. Three plates are welded together to form the beam shown. Knowing that all = 150MPa (both in tension and in compression), determine the minimum flange width b which may be used. 7. The beam shown in the figure is subjected to a uniformly distributed loading of ' W ' N/m. (a) Draw the bending moment diagram for this beam in terms of ' W '. (b) If the cross-section is as shown, and if the allowable tensile stress of the material is 200MPa, and if the allowable compressive stress of the material is 150MPa, determine the maximum load ' W ' the beam can carry. ENGINEER 2P04 Practice Problem Set: 10 Page 3 of 3 8*. 9. 10*. A B...
View Full Document
This note was uploaded on 02/19/2010 for the course ENG 2P04 taught by Professor Sivakumaran during the Spring '10 term at McMaster University.
- Spring '10