C07holes_2010F09

# C07holes_2010F09 - from the Part Features Panel 4 Change...

This preview shows pages 1–9. Sign up to view the full content.

1 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Placing Hole Features The Hole Tool The Hole Options Dialog Box Positioning the Hole

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
2 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Investigate the Hole Options Hole Features
3 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Adding a Hole to an Existing Part

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
4 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Option: Start with a sketch
5 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology 1. Place the hole point center and locate with parametric dimensions and or geometric constraints. 2. Click the “Return” button to complete profile step. 3. Select the Hole Feature

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: from the Part Features Panel. 4. Change Termination to “Through All” and diameter to 1” and then “OK” button to complete the hole command. 6 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Placing a Hole Click the Hole Options icon - for this example, choose: type – simple diameter - 1 inch extents – through all This is a parametric dimension. Simple hole 7 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Countersunk 8 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Counterbored 9 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Threaded Hole diameter and Standard Thread Selection are not independent....
View Full Document

## This note was uploaded on 02/26/2010 for the course CS 1371 taught by Professor Stallworth during the Spring '08 term at Georgia Tech.

### Page1 / 9

C07holes_2010F09 - from the Part Features Panel 4 Change...

This preview shows document pages 1 - 9. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online