C22Inventor_Sections_2010F09

C22Inventor_Sections_2010F09 - CAD Sections Full Sections...

Info iconThis preview shows pages 1–5. Sign up to view the full content.

View Full Document Right Arrow Icon
Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology CAD Sections Full Sections Half Sections Offset Sections
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
2 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Creating a Section View Create the view you wish to section (*.idw file) Select the Section View icon (Create toolbar) Draw a Cutting Plane in an existing view at the proper location for the type of section view needed Select the side to place the view
Background image of page 2
3 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Cutting Plane Line Cutting Plane Line for Section View Select the view to be sectioned Sketch the cutting line Cursor position determines cut side
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
4 Sheet Course: Introduction to Engineering Graphics and Visualization copyright 2009, Georgia Institute of Technology Section View Identify the cutting plane line
Background image of page 4
Image of page 5
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 02/26/2010 for the course CS 1371 taught by Professor Stallworth during the Spring '08 term at Georgia Institute of Technology.

Page1 / 20

C22Inventor_Sections_2010F09 - CAD Sections Full Sections...

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online