combinded beam bending

combinded beam bending - Strain Gage Applications: A...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
Strain Gage Applications: A Circular Beam Under Combined Loading Joshua Sill Group 8B MAE 244 Sec 4 : Chuanyu Feng 11/10/05
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Introduction Strain can be used to find the stresses at any one point on a beam. By using a strain gage that is connected to a beam, the strains can be measured at that point. Then by using certain formulas, the stresses can be calculated. This is what is being done in this experiment. A strain gage is connected to a beam and then a load is applied to the end which creates stresses. The main objective is to measure the stresses at a certain point of the beam. Wheatstone Bridge circuits are used to measure the resistance change of the strain gage due to the applied load. Strain rosettes are used for determining the principal directions and stresses in combined torsion and bending of the end of the shaft. The stress will be measured at both 400 lbs and 800 lbs. The readings from the strain indicator are given for each strain gage and each load. The reading can then be recorded and used to calculate the stresses.
Background image of page 2
Schematic Beam Strain Gage Load Applicator Figure 1. Strain Indicator
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 8

combinded beam bending - Strain Gage Applications: A...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online