kuis chapter 3 - www.ccna4u.info Thank CHRIS www.ccna4u.org...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
www.ccna4u.info www.ccna4u.org Thank CHRIS Assessment System Skip to Time Left | Skip to Navigation | Skip to Assessment Items Take Assessment - EWAN Chapter 3 - CCNA Exploration: Accessing the WAN (Ve 4.0) Time Remaining: 00:43:35 Showing 1 of 2 Next> Page: 1 GO <Prev 1 Which two items allow the router to map data link layer addresses to network layer addresses in Frame Relay network? (Choose two.) ARP RARP Proxy ARP Inverse ARP LMI status messages ICMP 2 Refer to the exhibit. When troubleshooting a Frame Relay connection, an administrator entered t show interfaces s0/0 command and received the output shown in the exhibit. What are two pro reasons for this problem? (Choose two.) The cable between the CSU/DSU and the router is disconnected. The serial 0/0 interface is shutdown. The router is not configured for the same Frame Relay PVC as the switch.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
www.ccna4u.info www.ccna4u.org Thank CHRIS The LMI type on the Frame Relay switch is NOT ANSI. The address of the Frame Relay switch is not in the routing table. 3 Refer to the exhibit. Which statement explains why the Frame Relay connection between R1 and failing? Split horizon must be disabled. The LMI type must be specified. Logical subinterfaces must be used instead. The frame-relay map commands are using incorrect DLCIs. 4 Refer to the exhibit. Which two statements are true given the output shown? (Choose two.) The IP address of the local Frame Relay interface is 172.16.1.4. The local DLCI number is 401. Inverse ARP is being used on this connection. This interface is in the active state and in the process of negotiating configuration parameters Multicast is not enabled on this connection. 5
Background image of page 2
www.ccna4u.info www.ccna4u.org Thank CHRIS Refer to the exhibit. You are a network administrator who has been tasked with completing the F Relay topology that interconnects two remote sites. Router HQ belongs to both the 172.16.1.0/24 172.16.2.0/24 subnets with IP addresses of 172.16.1.3 and 172.16.2.3 respectively. Traffic betwe R1 and R2 must travel through HQ first. How should the serial interface on HQ be configured to complete the topology? one multipoint subinterface two point-to-point subinterfaces with the physical interface configured with two ip addresses one IP address on a point-to-point subinterface and one IP address on the physical interface 6 Which three actions does a Frame Relay switch perform when it detects an excessive build-up o frames in its queue? (Choose three.) puts a hold on accepting frames in excess of the CIR drops frames from the queue that have the DE bit set reduces the number of frames it sends over the link re-negotiates flow control with the connected device
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 03/19/2010 for the course CCNA ct438 taught by Professor Markgreen during the Spring '10 term at Notre Dame de Namur.

Page1 / 11

kuis chapter 3 - www.ccna4u.info Thank CHRIS www.ccna4u.org...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online