This preview shows pages 1–3. Sign up to view the full content.
L303.4.R3
41
Drexel University
Electrical and Computer Engr. Dept.
Electrical Engineering Laboratory III, ECE L303
E. L. Gerber
ANALOGTODIGITAL
CONVERSION
Object
The object of this experiment is to learn the elements of an analogtodigital
converter and to utilize an analogtodigital chip in the Laboratory.
Introduction
An analog signal is one that can assume any voltage value as a function of time,
e.g., sine waves, speech waveforms, etc.
In contrast, a digital binary signal can assume
only two values called “1” and “0”; for transistortransistorlogic (TTL) the 1 state is
approximately +5 V and the 0 state is 0 V.
If we wish to transfer analog signals from one point to another with minimum
interference from noise, or if we need to change the form or characteristics of the signal,
we need to convert the analog signal to a digital signal.
The conversion process consists
of taking sample points on the analog waveform (see Fig. 1) and converting each point a
digital word.
The more points we take, the closer the sampled waveform follows the
original waveform. A series of binary words will represent the analog signal over a time
interval.
Theory
In the analog waveform shown in the Figure 1, the signal has a maximum value
of +3.1 V.
Let us assume that after processing and transmission, we would like the
analog signal to be restored to within 0.1 V of its original value.
We can determine the
required resolution
by dividing the 3.1 V into 0.1V increments.
With a signal range of 0
to +3.1 V, we have 32 steps of 0.1 V each, i.e., 0, 0.1, 0.2
…
3.1V, which gives a resolution
of 1/32 = 1/2
n
. Also the resolution can be expressed in terms of the fullscale voltage,
that is, V
FS
/(2
n
 1) volts per bit. In this example we have 3.1/(32  1) = 0.1 volts/bit.
To represent these 32 steps as a digital word requires five bits (2
5
= 32). With five
bits we can get 32 combinations of ones and zeros.
Zero volts can be represented by the
binarycoded decimal count of 00000, and 0.1 V by 00001, and so on.
At each particular
sample time, a digital word consisting of five bits is generated for each particular analog
value. This process must be repeated many times.
This preview has intentionally blurred sections. Sign up to view the full version.
View Full Document L303.4.R3
42
Figure 1.
Sampling an Analog Waveform
Analogtodigital (A/D) converters are integrated circuit devices that perform
the described conversion process.
There are four basic types of A/D converters:
1. Successive approximation
2. Flash
3. Dual slope
4. Tracking
The successive approximation A/D converter is used where reasonably fast
conversion is required.
The flashtype A/D converter is used for fastchanging analog
input signals.
Dual slope conversion is slow, but offers excellent rejection of power
supply noise.
Finally, the tracking converter is faster than the dual slope, but slower
than the successive approximation or flash types. We will investigate the successive
approximation converter in this experiment.
• Successive Approximation A/D Converter
This is the end of the preview. Sign up
to
access the rest of the document.
This note was uploaded on 04/05/2010 for the course ECEC 303 taught by Professor Gerber during the Spring '10 term at Drexel.
 Spring '10
 GERBER

Click to edit the document details