This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: V. Transistors 3.1 Bipolar-Junction (BJT) Transistors A bipolar junction transistor is formed by joining three sections of semiconductors with alternatively different dopings. The middle section (base) is narrow and one of the other two regions (emitter) is heavily doped. Two variants of BJT are possible: NPN and PNP. B B C E C C E B E NPN Transistor n p + n Circuit Symbols B C E C C B E B E n p Circuit Symbols + PNP Transistor p We will focus on NPN BJTs. Operation of a PNP transistor is analogous to that of a NPN transistor except that the role of “majority” charge carries reversed. In NPN transistors, electron flow is dominant while PNP transistors rely mostly on the flow of “holes.” Therefore, to zeroth order, NPN and PNP transistors behave similarly except the sign of current and voltages are reversed. i.e., PNP = − NPN ! In practice, NPN transistors are much more popular than PNP transistors because electrons move faster in a semiconductor. As a results, a NPN transistor has a faster response time compared to a PNP transistor. At the first glance, a BJT looks like 2 diodes placed back to back. Indeed this is the case if we apply voltage to only two of the three terminals, letting the third terminal float. This is also the way that we check if a transistor is working: use an ohm-meter to ensure both diodes are in working conditions. (One should also check the resistance between CE terminals and read a vary high resistance as one may have a burn through the base connecting collector and emitter.) The behavior of the BJT is different, however, when voltage sources are attached to both BE and CE terminals. The BE junction acts like a diode. When this junction is forward biased, electrons flow from emitter to the base (and a small current of holes from base to emitter). The base region is narrow and when a voltage is applied between collector and emitter, most of the electrons that were flowing from emitter to base, cross the narrow base region and are collected at the collector region. So while the BC junction is reversed biased, a large current can flow through that region and BC junction does not act as a diode. The amount of the current that crosses from emitter to collector region depends strongly on the voltage applied to the BE junction, v BE . (It also depends weakly on voltage applied ECE65 Lecture Notes (F. Najmabadi), Fall 2009 63 between collector and emitter, v CE .) As such, small changes in v BE or i B controls a much larger collector current i C . Note that the transistor does not generate i C . It acts as a valve controlling the current that can flow through it. The source of current (and power) is the power supply that feeds the CE terminals....
View Full Document
This note was uploaded on 04/15/2010 for the course ECE ECE65 taught by Professor Najmabadi during the Fall '09 term at UCSD.
- Fall '09