lab2 - University of California, San Diego Department of...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: University of California, San Diego Department of Electrical and Computer Engineering ECE65, Fall 2009 Lab 2, Diode wave-form shaping circuits In these experiments we examine diode circuits that modify the input wave-form. In these cases (and in many future experiments) you are asked to print out scope traces of input and output voltages of the circuit. You should follow this procedure: 1) Attach Scope channel 1 to v i and Scope Channel 2 to v o . 2) Move the two traces such that the zero voltage value for both channels are in the middle of the display. 3) Expand the time selection so that only 2 to 3 periods of the wave-form are shown. 4) Adjust the volt per division knob such that the signal is as large as possible ( i.e., fills the display). Ensure that both channels have the same volt per division setting. 5) Printout the trace. In this manner v o and v i can be directly compared. Experiment 1: Rectifier & Peak Detector Circuit Consider the circuit below with a 1N4148 general purpose diode and...
View Full Document

This note was uploaded on 04/15/2010 for the course ECE ECE65 taught by Professor Najmabadi during the Fall '09 term at UCSD.

Page1 / 2

lab2 - University of California, San Diego Department of...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online