Body Dimensions - DI-2 BODY DIMENSIONS Three-dimensional...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
GENERAL INFORMATION 1. BASIC DIMENSIONS (a) There are two types of dimensions in the diagram. (Three-dimensional distance) S Straight-line distance between the centers of two measuring points. (Two-dimensional distance) S Horizontal distance in forward/rearward between the centers of two measuring points. S The height from an imaginary standard line. (b) In cases in which only one dimension is given, left and right are symmetrical. (c) The dimensions in the following drawing indicate actual distance. Therefore, please use the dimen- sions as a reference. 2. MEASURING (a) Basically, all measurements are to be done with a tracking gauge. For portions where it is not possible to use a tracking gauge, a tape measure should be used. (b) Use only a tracking gauge that has no looseness in the body, measuring plate, or pointers. HINT: 1. The height of the left and right pointers must be equal. 2. Always calibrate the tracking gauge before measuring or after adjusting the pointer height. 3. Take care not to drop the tracking gauge or otherwise shock it. 4. Confirm that the pointers are securely in the holes. (c) When using a tape measure, avoid twists and bends in the tape. (d) When tracking a diagonal measurement from the front spring support inner hole to the suspension member upper rear installation hole, measure along the front spring support panel surface. Center-to-center straight-line distance Three-dimensional distance Front Spring Support Inner Hole Tape Measure Along Body Surface Front Suspension Member Rear Side Upper Installation Hole Master Gauge Pointer Pointer Looseness Body Looseness Plate Looseness Two-dimensional distance Center-to-center Horizontal distance in forward/rearward Vertical distance in lower surface Vertical distance in center Imaginary Standard Line Wrong Correct Pointer BODY DIMENSIONS DI-2
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Vehicle Dimensions Left Right 625 (24.61) C-L or C-l 1,686 (66.38) C-l or c-L (Three-Dimensional Distance) HINT: For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (Seen from rear). mm (in.) 1,598 (62.91) L-l Hole dia. 13 (0.51)
Background image of page 2
Image of page 3
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 05/03/2010 for the course BUSINESS econ203 taught by Professor Shivaggo during the Spring '10 term at Columbia College.

Page1 / 11

Body Dimensions - DI-2 BODY DIMENSIONS Three-dimensional...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online