The output is revised tolerances that guarantee

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ant impact on the diameter of the drilled hole. 4.3 Tip Error t tip The tip error in the x and y directions ( U xip and U y ) are determined by the superposition of the mean kinematic and static errors (Table IV). The error due to forces is considered with the forces at their nominal dimensions. Table IV Tip error due to kinematic and static effects. Parameter Error t U xip 0.240µm -0.109µm U tip y Table IV indicates that the error in the horizontal direction is much more significant than the error in the vertical direction. These horizontal and vertical errors in the tip due to combined kinematic and static effects exceed the desired dimensions of the hole. Therefore, a hole of such a small size may not be obtainable from the current drill architecture. From the previous two sections, it is observed that the tip’s error due to static effects is 45% of that due to kinematic effects. Therefore, correction of the kinematic error could lead to significant improvements in the tip’s position and t...
View Full Document

This note was uploaded on 08/03/2010 for the course DD 1234 taught by Professor Zczxc during the Spring '10 term at Magnolia Bible.

Ask a homework question - tutors are online