These errors are in turn affected by the tip and

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ar on Computer-Aided Tolerancing, Univ. of Twente, Enschede, Netherlands, March 22-24 (ed. F. vanHouten and H. Kals), pp. 177-86. [Giordano, et al., 2001] Giordano, M., Kataya, B., and Samper, S. “Tolerance analysis and synthesis by means of clearance and deviation spaces.” In Geometric Product Specification and Verification, Proc., 7th CIRP Int'l Seminar on CAT, Ecole Norm. Superieure, Cachan, France, April 24-25, (eds. P. Bourdet and L. Mathieu), pp. 345354. [ISO, 1983] International Organization for Standardization ISO 1101. (1983). Geometric tolerancing—Tolerancing of form, orientation, location, and run-out—Generalities, definitions, symbols, and indications on drawings. [Jian, 2001] Jian A.D. (2001), The Tolerance -Map® and its application to one stack up in a power saw. M.S. Thesis, Arizona State University. [Mujezinović, et al., 2004] Mujezinović, A., Davidson, J.K., and Shah, J. J. “A New Mathematical Model for Geometric Tolerances as Applied to Polygonal Faces”, ASME Tra...
View Full Document

This note was uploaded on 08/03/2010 for the course DD 1234 taught by Professor Zczxc during the Spring '10 term at Magnolia Bible.

Ask a homework question - tutors are online