G davidson hunt 2004 coordinates p and q are scaled

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: tablish the variations for sizes and positions of the two holes in the plate. According to the Standards [ASME, 1994 and ISO, 1983], the feature control frame XXXXXXXXX specifies a tolerance-zone (Fig. 1(b)) for each of the two holes. Each tolerance-zone is a very thin right-circular cylinder of length j and defined by circles C and C of diameter t, which are located in the upper and lower faces of the plate. The tolerance zone is exactly perpendicular to Datum A (Fig. 1(a)) and exactly located with dimensions a and b (or c) from Datums C and B, respectively. 5.1 4.9 0.1 A B C 0.08 Z $6 11.1 10.9 0.1 A B C 0.05 A $8 $9 $7 $2 C χ S $1 S $3 B $5 $4 A B j a b j j (a) O y c C x sE D A Oc (b) C Figure 1. a) Two holes in a plate of thickness j. Both holes are located with the tolerance t = 0.1 mm. The larger hole is to be held perpendicular to Datum A with the tolerance t” = 0.5 mm. b) A cylindrical tolerance-zone for the axis of a hole determined by circles C and C, each with its diameter equal to the positional tolerance t. Basis-lines $1…$5 are shown,...
View Full Document

This note was uploaded on 08/03/2010 for the course DD 1234 taught by Professor Zczxc during the Spring '10 term at Magnolia Bible.

Ask a homework question - tutors are online