LAB 4 - FAN system FAN config. Exp. Results

LAB 4 - FAN system FAN config. Exp. Results -...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Experimental Results Prompt : Results analyzed correctly. Results adequately and specifically summarize experimental findings. The data we obtained in the figure 1 was used to calculate rate of heat generated, thermal resistance from the junction-to-case and case-to-ambient, the junction temperature for series fans with high impedance configuration if power output was doubled. Chart 1 was also included to clearly display the temperature distribution of the data collected. With the calculated rate of heat generated, and thermal resistance, we calculated the percentage of heat that was lost through the PCB, re-calculate the thermal resistance from the junction-to-case and case-to-ambient, series fans with high impedance data, the junction temperature if the thermal resistance of the case to ambient were 1.7 °C/W. T’s (°C) Test Run Time (min) Chassis Temp (Tamb) Case Temp(Tcase) Tjunction (Tj) Board Temp (Tboard) Resistor Voltage (V) (1) Parallel fans with high impedance 8.0 28.0 56.9 61.1 34.0 4.94....
View Full Document

This note was uploaded on 09/08/2010 for the course ME 115 at San Jose State University .

Page1 / 3

LAB 4 - FAN system FAN config. Exp. Results -...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online