HW1 Solutions

# HW1 Solutions - EM 319 Mechanics of Solids Fall 2010...

This preview shows pages 1–5. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: EM 319 Mechanics of Solids Fall 2010 Homework #1 Due: 9/2/2010 1. Loads are applied at sections A, B, C, and D. If the bar has a cross-sectional area of 3 in 2 , determine the stress in the bar a. On a section 10 in. to the right of A b. On a section 60 in. to the right of A Fig. P1 Solution: 2. Axial loads are applied with rigid bearing plates to the concrete structure shown in Fig. P2. The cross-sectional areas for the concrete sections are 15,000 mm 2 for AB, 3000 mm 2 for BC and 10,000 mm 2 for CD. Determine the axial stress in the concrete. a. On a cross section in the interval AB b. On a cross section in the interval BC c. On a cross section in the interval CD Fig. P2 Solution: 3. A 2024-T4 aluminum tube with a wall thickness of 0.120 in. and an outside diameter of 1.000 in. is used as a compression member. Determine the axial load on the member when the axial stress is -30 ksi. Solution: 4. The round bar of Fig. P4 has steel, brass, and aluminum sections. Axial loads are applied at cross sections A, B, C and D. If the allowable axial stresses are 125 MPa in the steel, 70 MPa in the brass, and 85 MPa in the aluminum, determine the required diameters for each of the sections....
View Full Document

## This note was uploaded on 09/10/2010 for the course EM 13785 taught by Professor Hallali during the Fall '10 term at University of Texas at Austin.

### Page1 / 8

HW1 Solutions - EM 319 Mechanics of Solids Fall 2010...

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online